CLIA Kit for Parathyroid Hormone (PTH)

iPTH; Intact Parathyroid Hormone; Parathormone; Parathyrin

  • CLIA Kit for Parathyroid Hormone (PTH) Packages (Simulation)
  • CLIA Kit for Parathyroid Hormone (PTH) Packages (Simulation)
  • CLIA Kit for Parathyroid Hormone (PTH) Results demonstration
  • CCA866Ra.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the CLIA Kit for Parathyroid Hormone (PTH)

This assay has high sensitivity and excellent specificity for detection of Parathyroid Hormone (PTH).
No significant cross-reactivity or interference between Parathyroid Hormone (PTH) and analogues was observed.

Recovery of the CLIA Kit for Parathyroid Hormone (PTH)

Matrices listed below were spiked with certain level of recombinant Parathyroid Hormone (PTH) and the recovery rates were calculated by comparing the measured value to the expected amount of Parathyroid Hormone (PTH) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 80-89 83
EDTA plasma(n=5) 89-99 96
heparin plasma(n=5) 82-93 85

Precision of the CLIA Kit for Parathyroid Hormone (PTH)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Parathyroid Hormone (PTH) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Parathyroid Hormone (PTH) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the CLIA Kit for Parathyroid Hormone (PTH)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Parathyroid Hormone (PTH) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 88-104% 88-95% 78-91% 96-105%
EDTA plasma(n=5) 87-101% 98-105% 90-102% 92-101%
heparin plasma(n=5) 91-105% 93-102% 89-103% 88-101%

Stability of the CLIA Kit for Parathyroid Hormone (PTH)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the CLIA Kit for Parathyroid Hormone (PTH)

1. Prepare all reagents, samples and standards;
2. Add 50µL standard or sample to each well.
    And then add 50µL prepared Detection Reagent A immediately.
    Shake and mix. Incubate 1 hour at 37°C;
3. Aspirate and wash 3 times;
4. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
5. Aspirate and wash 5 times;
6. Add 100µL Substrate Solution. Incubate 10 minutes at 37°C;
7. Read RLU value immediately.

Test principle of the CLIA Kit for Parathyroid Hormone (PTH)

The microplate provided in this kit has been pre-coated with a monoclonal antibody specific to Parathyroid Hormone (PTH). A competitive inhibition reaction is launched between biotin labeled Parathyroid Hormone (PTH) and unlabeled Parathyroid Hormone (PTH) (Standards or samples) with the pre-coated antibody specific to Parathyroid Hormone (PTH). After incubation the unbound conjugate is washed off. Next, avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. The amount of bound HRP conjugate is reverse proportional to the concentration of Parathyroid Hormone (PTH) in the sample. Then the mixture of substrate A and B is added to generate glow light emission kinetics. Upon plate development, the intensity of the emitted light is reverse proportional to the Parathyroid Hormone (PTH) level in the sample or standard.

Related products

Catalog No. Organism species: Rattus norvegicus (Rat) Applications (RESEARCH USE ONLY!)
APA866Ra01 Active Parathyroid Hormone (PTH) Cell culture; Activity Assays.
RPA866Ra01 Recombinant Parathyroid Hormone (PTH) Positive Control; Immunogen; SDS-PAGE; WB.
CPA866Ra11 BSA Conjugated Parathyroid Hormone (PTH) Immunogen; SDS-PAGE; WB.
CPA866Ra21 OVA Conjugated Parathyroid Hormone (PTH) Immunogen; SDS-PAGE; WB.
PAA866Ra08 Polyclonal Antibody to Parathyroid Hormone (PTH) WB; IHC; ICC; IP.
PAA866Ra01 Polyclonal Antibody to Parathyroid Hormone (PTH) WB; IHC; ICC; IP.
MAA866Ra21 Monoclonal Antibody to Parathyroid Hormone (PTH) WB; IHC; ICC; IP.
CEA866Ra ELISA Kit for Parathyroid Hormone (PTH) Enzyme-linked immunosorbent assay for Antigen Detection.
CCA866Ra CLIA Kit for Parathyroid Hormone (PTH) Chemiluminescent immunoassay for Antigen Detection.
LMA866Ra Multiplex Assay Kit for Parathyroid Hormone (PTH) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
KSA866Ra11 ELISA Kit DIY Materials for Parathyroid Hormone (PTH) Main materials for "Do It (ELISA Kit) Yourself".
GUESTBOOK