CLIA Kit for Enhancer Of Zeste Homolog 2 (EZH2)

ENX-1; KMT6; KMT6A; Histone-lysine N-methyltransferase EZH2; Lysine N-methyltransferase 6

  • CLIA Kit for Enhancer Of Zeste Homolog 2 (EZH2) Packages (Simulation)
  • CLIA Kit for Enhancer Of Zeste Homolog 2 (EZH2) Packages (Simulation)
  • CLIA Kit for Enhancer Of Zeste Homolog 2 (EZH2) Results demonstration
  • SCK073Hu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the CLIA Kit for Enhancer Of Zeste Homolog 2 (EZH2)

This assay has high sensitivity and excellent specificity for detection of Enhancer Of Zeste Homolog 2 (EZH2).
No significant cross-reactivity or interference between Enhancer Of Zeste Homolog 2 (EZH2) and analogues was observed.

Precision of the CLIA Kit for Enhancer Of Zeste Homolog 2 (EZH2)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Enhancer Of Zeste Homolog 2 (EZH2) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Enhancer Of Zeste Homolog 2 (EZH2) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Stability of the CLIA Kit for Enhancer Of Zeste Homolog 2 (EZH2)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the CLIA Kit for Enhancer Of Zeste Homolog 2 (EZH2)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 100µL Substrate Solution. Incubate 10 minutes at 37°C;
8. Read RLU value immediately.

Test principle of the CLIA Kit for Enhancer Of Zeste Homolog 2 (EZH2)

The microplate provided in this kit has been pre-coated with an antibody specific to Enhancer Of Zeste Homolog 2 (EZH2). Standards or samples are then added to the appropriate microplate wells with a biotin-conjugated antibody specific to Enhancer Of Zeste Homolog 2 (EZH2). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. Then the mixture of substrate A and B is added to generate glow light emission kinetics. Upon plate development, the intensity of the emitted light is proportional to the Enhancer Of Zeste Homolog 2 (EZH2) level in the sample or standard.;

Related products

Catalog No. Organism species: Homo sapiens (Human) Applications (RESEARCH USE ONLY!)
RPK073Hu01 Recombinant Enhancer Of Zeste Homolog 2 (EZH2) Positive Control; Immunogen; SDS-PAGE; WB.
RPK073Hu02 Recombinant Enhancer Of Zeste Homolog 2 (EZH2) Positive Control; Immunogen; SDS-PAGE; WB.
PAK073Hu02 Polyclonal Antibody to Enhancer Of Zeste Homolog 2 (EZH2) WB; IHC; ICC; IP.
PAK073Hu01 Polyclonal Antibody to Enhancer Of Zeste Homolog 2 (EZH2) WB; IHC; ICC; IP.
SEK073Hu ELISA Kit for Enhancer Of Zeste Homolog 2 (EZH2) Enzyme-linked immunosorbent assay for Antigen Detection.
SCK073Hu CLIA Kit for Enhancer Of Zeste Homolog 2 (EZH2) Chemiluminescent immunoassay for Antigen Detection.
GUESTBOOK