CLIA Kit for Collagen Type II (COL2)

  • CLIA Kit for Collagen Type II (COL2) Packages (Simulation)
  • CLIA Kit for Collagen Type II (COL2) Packages (Simulation)
  • CLIA Kit for Collagen Type II (COL2) Results demonstration
  • SCA572Hu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the CLIA Kit for Collagen Type II (COL2)

This assay has high sensitivity and excellent specificity for detection of Collagen Type II (COL2).
No significant cross-reactivity or interference between Collagen Type II (COL2) and analogues was observed.

Recovery of the CLIA Kit for Collagen Type II (COL2)

Matrices listed below were spiked with certain level of recombinant Collagen Type II (COL2) and the recovery rates were calculated by comparing the measured value to the expected amount of Collagen Type II (COL2) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 86-94 91
EDTA plasma(n=5) 78-89 85
heparin plasma(n=5) 86-99 93

Precision of the CLIA Kit for Collagen Type II (COL2)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Collagen Type II (COL2) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Collagen Type II (COL2) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the CLIA Kit for Collagen Type II (COL2)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Collagen Type II (COL2) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 88-96% 80-94% 84-91% 85-96%
EDTA plasma(n=5) 79-90% 79-96% 82-93% 78-95%
heparin plasma(n=5) 86-93% 98-105% 94-102% 87-101%

Stability of the CLIA Kit for Collagen Type II (COL2)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the CLIA Kit for Collagen Type II (COL2)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 100µL Substrate Solution. Incubate 10 minutes at 37°C;
8. Read RLU value immediately.

Test principle of the CLIA Kit for Collagen Type II (COL2)

The microplate provided in this kit has been pre-coated with an antibody specific to Collagen Type II (COL2). Standards or samples are then added to the appropriate microplate wells with a biotin-conjugated antibody specific to Collagen Type II (COL2). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. Then the mixture of substrate A and B is added to generate glow light emission kinetics. Upon plate development, the intensity of the emitted light is proportional to the Collagen Type II (COL2) level in the sample or standard.;

Related products

Catalog No. Organism species: Homo sapiens (Human) Applications (RESEARCH USE ONLY!)
PAA572Hu01 Polyclonal Antibody to Collagen Type II (COL2) WB; IHC; ICC; IP.
SEA572Hu ELISA Kit for Collagen Type II (COL2) Enzyme-linked immunosorbent assay for Antigen Detection.
AEA572Hu ELISA Kit for Anti-Collagen Type II Antibody (Anti-COL2) Enzyme-linked immunosorbent assay for Antibody Detection.
SCA572Hu CLIA Kit for Collagen Type II (COL2) Chemiluminescent immunoassay for Antigen Detection.
GUESTBOOK