CLIA Kit for Anti-Mullerian Hormone (AMH)

MIF; MIH; MIS; Müllerian Inhibiting Factor; Müllerian Inhibiting Hormone; Müllerian Inhibiting Substance

  • CLIA Kit for Anti-Mullerian Hormone (AMH) Packages (Simulation)
  • CLIA Kit for Anti-Mullerian Hormone (AMH) Packages (Simulation)
  • CLIA Kit for Anti-Mullerian Hormone (AMH) Results demonstration
  • CCA228Ra.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the CLIA Kit for Anti-Mullerian Hormone (AMH)

This assay has high sensitivity and excellent specificity for detection of Anti-Mullerian Hormone (AMH).
No significant cross-reactivity or interference between Anti-Mullerian Hormone (AMH) and analogues was observed.

Recovery of the CLIA Kit for Anti-Mullerian Hormone (AMH)

Matrices listed below were spiked with certain level of recombinant Anti-Mullerian Hormone (AMH) and the recovery rates were calculated by comparing the measured value to the expected amount of Anti-Mullerian Hormone (AMH) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 99-105 102
EDTA plasma(n=5) 92-101 96
heparin plasma(n=5) 83-96 90

Precision of the CLIA Kit for Anti-Mullerian Hormone (AMH)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Anti-Mullerian Hormone (AMH) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Anti-Mullerian Hormone (AMH) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the CLIA Kit for Anti-Mullerian Hormone (AMH)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Anti-Mullerian Hormone (AMH) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 82-103% 91-101% 79-103% 92-104%
EDTA plasma(n=5) 93-102% 83-92% 96-105% 79-102%
heparin plasma(n=5) 78-105% 94-102% 95-105% 88-95%

Stability of the CLIA Kit for Anti-Mullerian Hormone (AMH)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the CLIA Kit for Anti-Mullerian Hormone (AMH)

1. Prepare all reagents, samples and standards;
2. Add 50µL standard or sample to each well.
    And then add 50µL prepared Detection Reagent A immediately.
    Shake and mix. Incubate 1 hour at 37°C;
3. Aspirate and wash 3 times;
4. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
5. Aspirate and wash 5 times;
6. Add 100µL Substrate Solution. Incubate 10 minutes at 37°C;
7. Read RLU value immediately.

Test principle of the CLIA Kit for Anti-Mullerian Hormone (AMH)

The microplate provided in this kit has been pre-coated with a monoclonal antibody specific to Anti-Mullerian Hormone (AMH). A competitive inhibition reaction is launched between biotin labeled Anti-Mullerian Hormone (AMH) and unlabeled Anti-Mullerian Hormone (AMH) (Standards or samples) with the pre-coated antibody specific to Anti-Mullerian Hormone (AMH). After incubation the unbound conjugate is washed off. Next, avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. The amount of bound HRP conjugate is reverse proportional to the concentration of Anti-Mullerian Hormone (AMH) in the sample. Then the mixture of substrate A and B is added to generate glow light emission kinetics. Upon plate development, the intensity of the emitted light is reverse proportional to the Anti-Mullerian Hormone (AMH) level in the sample or standard.

Related products

Catalog No. Organism species: Rattus norvegicus (Rat) Applications (RESEARCH USE ONLY!)
RPA228Ra01 Recombinant Anti-Mullerian Hormone (AMH) Positive Control; Immunogen; SDS-PAGE; WB.
PAA228Ra01 Polyclonal Antibody to Anti-Mullerian Hormone (AMH) WB; IHC; ICC; IP.
LAA228Ra71 Biotin-Linked Polyclonal Antibody to Anti-Mullerian Hormone (AMH) WB; IHC; ICC.
MAA228Ra21 Monoclonal Antibody to Anti-Mullerian Hormone (AMH) WB; IHC; ICC; IP.
CEA228Ra ELISA Kit for Anti-Mullerian Hormone (AMH) Enzyme-linked immunosorbent assay for Antigen Detection.
WEA228Ra Wide-range ELISA Kit for Anti-Mullerian Hormone (AMH) Enzyme-linked immunosorbent assay for Antigen Detection.
CCA228Ra CLIA Kit for Anti-Mullerian Hormone (AMH) Chemiluminescent immunoassay for Antigen Detection.
LMA228Ra Multiplex Assay Kit for Anti-Mullerian Hormone (AMH) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
KSA228Ra11 ELISA Kit DIY Materials for Anti-Mullerian Hormone (AMH) Main materials for "Do It (ELISA Kit) Yourself".
GUESTBOOK